Hook up multiple routers together
All rights not expressly granted to you by Belkin under this Agreement are hereby reserved by Belkin. While most home computer networks only use one router, adding a second router makes sense in a few situations: Enter two DNS server addresses if you want to use different servers.
Turns out all I needed to do was change the ethernet connection and reconfigure the IP address. The Software is licensed, not sold, to you. I have an Ethernet cable installed through the walls with which I can interconnect the two routers.
You should be able to use the same network name; the IP addresses are what manage the distinction. Enter the address for the default gateway, which is the local address of the gateway. Therefore, you must treat the Software like any other material protected by laws and treaties relating to international property rights and in accordance with this Agreement. Not Helpful 0 Helpful 3. Rather, the terms and conditions in the applicable Open Source Software license shall apply to the Open Source Software.
Is this article up to date? Enter this as the DHCP address range.
Assign a name to your network and enter it into the SSID field.
Was this support article useful? This license does not apply to Open Source Software contained in the Software.
Connect the other end of the Ethernet cable to a laptop or desktop computer to use when configuring the gateway.
For example, you might have the primary labeled "Den" and the secondary labeled "LivingRoom". Your primary router will be configured as you normally would for a wireless network. Save your changes, reboot the router and log back in to the router at its new address, for example No failure or delay in exercising any right or remedy shall operate as a waiver of any such or any other right or remedy.
Both wired and wireless routers are best configured from a computer connected via Ethernet network cable. Enter the default gateway, which is the local address of the gateway.
Configure the wireless settings for this router if it's also going to function as an access point. This will be the router that your modem is connected to. You only have the non-exclusive right to use the Software in accordance with this Agreement.
Connect your main router to your modem, then connect your computer to the router via Ethernet. How do I bridge together two wireless routers?
Enter a unique SSID. If you intend to set up a hook up multiple routers together so you can remotely access your main computer, OpenVPN will do anything you need -- it's free and a fully-featured, enterprise-grade solution.
Prepare to Configure
This method is officially supported only by selected router models. You agree to strictly comply with all export control laws and regulations and agree not to export, re-export, divert, transfer or disclose any portion of the Software or any related technical information or materials, directly or indirectly, in hook up multiple routers together of any applicable export law or regulation.
This will help you know which router on the network you are connecting to. Took me about 7 minutes to set up the home network. You explained how to do it in detail and in simple terms. Not Helpful 3 Helpful 9. You need to make sure your computer is directly connected to the base station, not one of the satellites and access the base stations config page at